Help Center · Installations
We've gone over a million different ways to install our horns onto cars, trucks, SUV's, and even smart cars. Did you know that horns can also be used in stadiums and other buildings? In this article we'll go over different use cases and best practices for installing horns on any building.
Our horns are currently used within the Mercedes Benz Stadium in Atlanta, Georgia. Here the Atlanta Falcons NFL Football team use not one but three of our Nathan Airchime K5 train horns. Working in unison, these horns provide the ultimate hype for the crowd with the tone and power of three locomotives!
There are quite a few ways you could set this up. We typically recommend purchasing an air compressor from a local hardware store for convenience. Compressors found at Home Depot or Lowe's can be run off the power in your building (110-volt), whereas the compressors in our kits are designed to operate off the vehicle's electrical (12-24 volts). You won't need anything fancy and there are quite a few inexpensive options that will work for the application.
Husky offers an 8-gallon compressor at Home Depot for $129.00 at the time of writing. You won't find another 8-gallon tank with a compressor at this price. If you are on a budget, this compressor would make a great match to most of our horns. To make the horns work with this air compressor, you will need to remove and replace the quick disconnect fitting on the air tank. Check out the image below:
This compressor (and most you can buy) will come with a quick disconnect pre-installed to serve as an air outlet. This fitting can be removed from the tank and replaced with an air line fitting to adapt to our horns. Using an adjustable wrench, line the wrench up over the hex-shaped portion of this fitting, and turn the fitting counter-clockwise. It will come out of the tank. With that removed, the new fitting can be installed.
The fitting pictured below will adapt the tank to the air line for the horn.
How do you plan to honk your horns? You can setup a big button to press, use a wireless remote, or both.
The horns are setup with an air valve in between the air tank and the horns themselves. When power is supplied, the air valve will open and the horns will honk. We do offer a 110-volt air valve that can be used with the power supplied in your building.
As it turns out, the valve can be wired to a switch or button just like a light bulb. If you are not familiar with 110v electricity, an electrician can help you in setting this up properly. When the switch or button is pressed, the air valve will open and your horns will honk. You could make this wireless as well using a 110v wireless remote.
This compressor operates much quieter than it's counterparts, rated at ~73 dba. This tank may be one of the best options for an arena or stadium given it's size, noise level and cost. At the time of writing this unit only costs $349.00.
Explore horn kits, electric horns, install brackets, and onboard air systems built for loud, reliable performance.
Return to the Help Center for more installation guides. For indoor arena use cases with HornBlasters vehicle-style kits, see the separate buildings/arenas article.
Help Center
Skip to content
