Coming down from the shadows to unleash an audible assault upon your enemies, the Ninja Air Horn packs a deadly punch. Perfect for anyone that wants a sharp, authoritative tone for a compact setup. Designed to give you a big sound on a small set-up, the long, single bell horn is matched with a direct drive compressor. Our HornBlasters Ninja Horn is perfect for smaller setups, such as motorcycles and ATVs where you don’t have room for a full onboard air system.
This product produces extreme loudness. Proper hearing protection must be worn at all times during its operation. Hearing loss or permanent damage may result from unsafe use. Use this product in a safe and responsible manner and at a distance of at least 100 meters from others. Never operate this product in a closed environment, in close proximity to living beings, or where prohibited by law.
This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov.
Have had this for about two years now. No issues. Instructions were clear. I did put a Filterswear cover over the end of the trumpet to prevent water, bugs, debris from getting in to it. I was concerned with the compressor durability given where I mounted it. It’s under the bikes horn cover and exposed to high temps. Not a single issue.
Trying to keep 2019 RAM Tradesman simple and uncomplicated but wanted to "juice up" the horn. Found great unused (must be structural and/or for accessories) bracket already near fuse box and with a couple of new holes and a bit of plastic shaved down all fits great so far. Short wire runs as all very close to the fuse box terminal for power. Wanted to activate with existing horn at the column so just spliced into the horn wire (grey/yellow stripped) under the F42 horn fuse. So far great install and CRAZY loud!! Alex diagram helped a lot...........
This is a great horn for the price! I received it the day after I ordered it!
Stock horns on my 2017 Miata weren’t loud enough to get others attention. This horn echoes and was easy to install with the wiring kit
Instead on my 20 ram 1500 ecodiesel and it's much louder than the stock horns. I have a toggle switch under the dash to turn it off at will, I used the wiring kit and it wasn't to painfully to install I tapped into the stock horn wire for signal and grounded and powered it up and love playing with it.